SDS Plus Hammer Drill Issue Face – Makita HR166DZ

The Makita HR166DZ features a powerful brushless DC motor with a fully brushless motor for greater efficiency to ensure long life and reliability. SDS Plus Hammer Drill. Besides this, for full power, it has 3 operating modes (RH, RO & HO). A Makita HR166DZ rotary hammer is a versatile tool capable of conducting heavy-duty operations such as hard material drilling and chiseling. It is similar to a hammer drill because, although it is still rotating, it pounds the drill bit in and out.

SDS Plus Hammer Drill Trouble Face:

There are a variety of problems that can arise that can slow down or even disrupt the job by using a hammer drill to drill through hard brittle materials such as concrete or glass. A few common problems that can occur while using a hammer drill, also known as a rotary hammer, are described below. When drilling into different substances.

Stops drilling with Drill Bit

The next biggest challenge you will face is where the drill bit begins to dig into the stuff when drilling into concrete or glass. This is caused by two events taking place. The first question is that not enough material is taken out of the cavity by the bit flutes. The other cause of a bound or stuck drill bit is triggered when the bit comes into contact with a piece of rock.

Jamming bits:

You need to interfere if your drill bit makes contact with a piece of rock that it can’t crack. Into the hole, drop a pointed rock punch or concrete nail. And strike it quickly with a hammer a few times to break the block. Use more power with the hammer if your first attempt to smash the rock isn’t successful.

Worn Fail is the Clutch Leaf Spring:

If the right gear isn’t firmly turned on by the clutch. The spring of the leaf may become worn out or merely missing. It is a normal occurrence for anyone to open a drill. And when reassembling, do not put the leaf spring back in its proper position.

Long Time Drill Used:

The drill tends to heat up when you’re using the drill for a long period of time. To stop drilling, simply let the button go and let the drill cool down.

Tips for Protection

Adjust the bit of the drill

Keep the ring and turn the sleeve counterclockwise to open the jaws of the chuck. Place the chuck in the bit as far as it goes. Keep the ring close, and to secure the chuck, turn the clockwise sleeve. To remove the bit, keep the ring and turn the sleeve counter-clockwise.

Tighten a bit of a drill

Hold the new bit with your thumb and index finger, then drop it down into the chuck. To hold the bit in place, squeeze the trigger several times, then twist the ratcheting device next to the chuck in a clockwise motion. Insert the key and turn it counterclockwise if you have a key on the chuck, and then slide the bit out.

Thanks for reading the message. We hope that you like the article and that it will benefit you.

For more information, please visit our website: www.toptopdeal.co.uk
Also email us at: –
info@toptopdeal.co.uk

Leave a Reply

Your email address will not be published. Required fields are marked *